Installing A Cpu - HP Z200 - Small Form Factor Workstation Maintenance And Service Manual

Installing a CPU

NOTE: HP recommends that you do not swap processors (CPUs) from one system board to another.
To install a CPU:
1. Prepare the computer for servicing by following the
CAUTION:
data loss.
2. Remove the access panel (see
3. Remove the airflow guide.
4. If necessary, remove the CPU heatsink (see
5. Using extreme care, fully raise the CPU socket lever and cover.
CAUTION:
care when installing the CPU in the socket.
6. Align the notches in the CPU base with the tabs on the socket as shown in the figure below.
Seat the CPU into the socket. Ensure that the underside of the CPU is level with the top of the CPU
socket.
Figure 5-59
7. Close the CPU cover plate by lightly pressing down on the CPU cover plate while closing the socket
lever.
8. Replace the CPU heatsink (see
9. Replace the access panel (see
10. Restore all connections and equipment that you removed during the
on page
122 Chapter 5 Replacing components
Failure to follow the predisassembly procedures can result in equipment damage or
Removing the access panel on page
The CPU socket contacts are delicate. To avoid bending the contacts, use extreme
Seating the CPU
Installing the access panel on page
68.
Predisassembly procedures on page
Removing the CPU heatsink on page
Installing the CPU heatsink on page
68.
71).
118).
119),
71).
Predisassembly procedures
ENWW