HP Z200 - Small Form Factor Workstation Maintenance And Service Manual page 111

7. Connect the front panel USB (1 and 2), front audio (3), and front power/LED (4) cables to the system
board as shown in the following diagram.
Figure 5-37
8. Rotate the drive cage down to its normal position.
9. Replace the front bezel (see
10. Replace the access panel (see
11. Restore all connections and equipment that you removed during the
on page
ENWW
Connecting the front panel I/O device cables
Installing the front bezel on page
Installing the access panel on page
68.
72).
71).
Predisassembly procedures
Removing and installing components 99