Installing An Expansion Card - HP Z200 - Small Form Factor Workstation Maintenance And Service Manual

Installing an expansion card

Visit http://www.hp.com/go/quickspecs
how much memory each graphics card includes, and graphics card power requirements.
To install an expansion card:
1. Prepare the computer for servicing by following the
CAUTION:
data loss.
2. Remove the access panel (see
3. Push the expansion card retention clamp levers down on the outside of the chassis to release the
retention clamp () as shown in the figure below.
Figure 5-52
114 Chapter 5 Replacing components
to learn which graphics cards are supported in the computer,
Failure to follow the predisassembly procedures can result in equipment damage or
Removing the access panel on page
Releasing the retention clamp
Predisassembly procedures on page
71).
68.
ENWW