3.
Remove the bezel blanks by squeezing in on the tabs (1) and simultaneously pushing the bezel
blanks out (2), as shown:
Figure 4-11
4.
Remove the bezel blank by applying outward pressure on the subpanel (1) and pulling the blank
away (2).
A bezel blank has a hook on both sides. It is symmetric and can be installed upside down without
issue. To replace a blank, align its hook on one side with the slot in the bezel, then rotate it until it
snaps into place.
Front panel I/O device assembly
This section describes how to remove and install a front panel I/O device assembly.
Removing the front panel I/O device assembly
To remove the front panel I/O device assembly:
1.
Disconnect power from the system (see
2.
Remove the side access panel (see
3.
Remove the front bezel (see
ENWW
Removing the bezel blanks
Removing the front bezel on page
Predisassembly procedures on page
Side access panel on page
Removing and replacing components
52).
58).
61).
63