Tools And Software Requirements; Special Handling Of Components; Cables And Connectors - HP Z200 - Small Form Factor Workstation Maintenance And Service Manual

Tools and software requirements

The tools necessary for computer component removal and installation are:
●
Torx T-15 driver
●
Flat blade and cross-tip screwdrivers
●
Diagnostics software

Special handling of components

The components included in this section require special handling when servicing the computer.
WARNING!
Lifting the computer from the front bezel, or lifting it incorrectly, could cause the computer to fall, causing
possible injury to you and damage to the computer. To properly and safely lift the computer, lift from the
bottom of the computer.
WARNING!
Lifting the computer from the front bezel, or lifting it incorrectly, could cause the computer to fall, causing
possible injury to you and damage to the computer. To properly and safely lift the computer, use the
handles. If the computer is not equipped with handles, lift from the bottom of the computer.

Cables and connectors

Handle cables with care to avoid damage. Apply only the tension required to seat or unseat cables
during insertion or removal from the connector. When possible, handle cables by the connector or pull-
strap. In all cases, avoid bending or twisting the cables, and be sure that the cables are routed in such
a way that they cannot be caught or snagged by parts being removed or replaced.
When servicing the computer, be sure that cables are placed in their proper location during the
reassembly process. Improper cable placement can damage the computer.
64 Chapter 5 Replacing components
Do not use the front bezel as a handle or lifting point when lifting or moving the computer.
Do not use the front bezel as a handle or lifting point when lifting or moving the computer.
ENWW