Battery; Removing The Battery - HP Z200 - Small Form Factor Workstation Maintenance And Service Manual

Battery

This section describes how to remove and install the battery.
The battery that comes with the computer provides power to the real-time clock and has a minimum
lifetime of about three years.
WARNING!
battery is handled improperly. Do not disassemble, crush, puncture, short external contacts, dispose of
in water or fire, or expose battery to temperatures higher than 60°C (140°F).
CAUTION:
battery is removed. To back up the CMOS settings, select the Save to Diskette option in the Computer
Setup (F10) Utility.
NOTE: Do not dispose of batteries, battery packs, and accumulators with general household waste.

Removing the battery

To remove the battery:
1. Prepare the computer for servicing by following the
CAUTION:
data loss.
2. Remove the access panel (see
3. On the system board, press the release tab of the battery holder.
4. Lift the battery straight up and out of the holder as shown in the following figure.
Figure 5-55
ENWW
This computer includes a lithium battery. There is a risk of fire and chemical burn if the
Before removing the battery, back up the CMOS settings in case they are lost when the
Failure to follow the predisassembly procedures can result in equipment damage or
Removing the battery
Predisassembly procedures on page
Removing the access panel on page 71).
Removing and installing components 117
68.