Bezel
This section describes how to remove and install the front chassis bezel.
Removing the front bezel
To remove the front bezel:
1.
Remove the side access panel (see
2.
Lift the release tabs (1), and then rotate the front bezel off the chassis (2).
Figure 5-9
Installing the front bezel
To install the front bezel, align the tabs discussed in the previous section and rotate the bezel until it
snaps in place.
Front panel I/O device assembly
This section describes how to remove and install a front panel I/O device assembly.
Removing the front panel I/O device assembly
To remove the front panel I/O device assembly:
1.
Power down the workstation (see
2.
Disconnect power from the workstation (see
3.
Remove the side access panel (see
ENWW
Removing the side access panel on page
Removing the front bezel
Predisassembly procedures on page
Removing the side access panel on page
Predisassembly procedures on page
Removing and installing components
78).
75).
75).
78).
83