Front Panel I/O Device Assembly - HP Xw8400 - Workstation - 4 GB RAM Technical Reference Manual

Hp xw8400 workstation - service and technical reference guide
Hide thumbs Also See for Xw8400 - Workstation - 4 GB RAM:
Table of Contents

Advertisement

3.
Slide the hood sensor forward.
4.
Push the hood sensor down and remove it from the chassis.
Figure 4-10
To replace the hood sensor, reverse the previous steps.

Front panel I/O device assembly

To remove the front panel I/O device assembly:
1.
Disconnect power from the system (
panel
(Access panel on page
2.
Unlatch the plastic snap that secures the cables inside the chassis and, disconnect the front panel
I/O device assembly cables from the system board.
3.
Remove the screws that hold the front panel I/O device assembly and bracket to the chassis, and
remove the screws that hold the front panel I/O device assembly to the bracket.
4.
Pull the front panel I/O device assembly out about two inches away from the chassis.
60
Chapter 4 Removal and replacement procedures
Removing the hood sensor
57) and the front bezel
Pre-disassembly procedures on page
(Front bezel on page
50). Remove the access
58).
ENWW

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents