Power supply
This section describes how to remove and install a power supply.
Removing the power supply
To remove the power supply:
1.
Prepare the computer for servicing by following the
CAUTION:
data loss.
2.
Remove the access panel (see
3.
Disconnect all of the power supply cables from the system board and all peripheral devices,
including hard drives, optical drives, and others as needed. (See
on page
4.
Rotate the drive cage to its upright position.
Figure 5-39
ENWW
Failure to follow the predisassembly procedures can result in equipment damage or
Removing the access panel on page
94.)
Rotating the drive cage up
Predisassembly procedures on page
71).
Power connections
Removing and installing components 101
68.