HP Z200 - Small Form Factor Workstation Maintenance And Service Manual page 121

5. Align the DIMM connector key with the DIMM socket key, and then seat the DIMM firmly in the
socket (1).
CAUTION:
damage, align these guides properly when installing DIMMs.
Figure 5-48
6. Secure the socket levers (2).
7. Rotate the drive cage and the power supply down to their normal positions.
8. Replace the front bezel (see
9. Replace the access panel (see
10. Restore all connections and equipment that you removed during the
on page
ENWW
DIMMs and their sockets are keyed for proper installation. To prevent socket or DIMM
Opening DIMM socket levers
Installing the front bezel on page
Installing the access panel on page
68.
72).
71).
Predisassembly procedures
Removing and installing components 109