Hood Lock (Smart Cover Lock) (Optional); Front Panel I/O Device Assembly - HP Xw6400 - Workstation - 4 GB RAM Reference Manual

Hood lock (Smart cover lock) (optional)

To remove the hood lock:
1. Disconnect power from the system
access panel
2. Using the FailSafe key, remove the two tamper-resistant screws that secure the hood lock to the
chassis.
Figure 4-10
3. Disconnect the hood lock cable from the system board and remove the lock assembly.
To install the hood lock, reverse the previous steps.

Front panel I/O device assembly

To remove the front panel I/O device assembly:
1. Disconnect power from the system
access panel
on page
2. Unlatch the plastic snap that secures the cables inside the chassis and disconnect the front panel
I/O device assembly cables from the system board.
3. Remove the screws 1 that hold the front panel I/O device assembly and bracket to the chassis and
remove the screws 2 that hold the front panel I/O device assembly to the bracket.
4. Pull the front panel I/O device assembly out 3 about 2 inches (5 cm) away from the chassis.
ENWW
(Side access panel on page
Removing the hood lock
(Side access panel on page
64).
(Predisassembly procedures on page
63), and remove the top cover
(Predisassembly procedures on page
63), and remove the front bezel
Removal and replacement of components
57), remove the side
(Top cover on page 65).
57), remove the side
(Front Bezel
67