4.
Rotate the drive cage to its upright position.
Figure 5-11
5.
Disconnect the power cable (1) and data cable (2) from the rear of the optical drive.
Figure 5-12
6.
Rotate the drive cage back down to its normal position.
CAUTION:
ENWW
Rotating the Drive Cage Up
Disconnecting the power and data cables
Be careful not to pinch any cables or wires when rotating the drive cage down.
Removing and installing components
81
Need help?
Do you have a question about the Z200 - Small Form Factor Workstation and is the answer not in the manual?