Installing Hard Drives In The Optical Drive Bays (Optional) - HP xw4400 Service And Technical Reference Manual

5. Connect the data cable from the hard drive 1 to the serial ATA port 2. SATA0 port is shown in the
following illustration.
●
Connect SATA 0 to SATA0.
●
Connect SATA 1 to SATA1.
Figure 4-50
To install three to four SATA hard drives:
1. Follow the instructions for installing two SATA hard drives above.
2. Follow the instructions for installing the hard drive into the optical drive slot.
NOTE
optical drive bay. If installing four SATA hard drives, you must install hard drives in at least
two optical drive bays.
3. Connect the data and power cable to the drives.
●
Connect SATA 2 to SATA2.
●
Connect SATA 3 to SATA3.

Installing hard drives in the optical drive bays (optional)

1. Disconnect power from the system
access panel
96 Chapter 4 Removal and replacement procedures
Connecting the SATA cable to the hard drive
If installing three SATA hard drives, you must install hard drives in at least one
(Predisassembly procedures on page
(Side access panel on page 66), and the front bezel
60), remove the side
(Front Bezel on page 67).
ENWW