Installing Dual Sff Hard Drives In The Optical Drive Bay; Installing The Hard Drives - HP Z600 Maintenance And Service Manual

Installing dual SFF hard drives in the optical drive bay

This section describes how to install two small form factor (SFF) hard drives in the workstation optical
drive bay, and how to connect the hard drive cables.

Installing the hard drives

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Remove the green rails from the bracket by squeezing the tabs and sliding the rails out of the
bracket.
4. Orient the drive with the connectors on the rear of the drive facing toward the tabs on the bracket
rails.
5. Gently open the rails
Figure 5-62
6. Lower the drive into the rails
the hard drive, and then snap the rails into place.
7. Carefully squeeze the green tabs
shown in the following figure.
Figure 5-63
ENWW
as shown in the following figure.
Installing the drive in the rails
as shown above. Align the four pins on the rails with the holes in
2
Installing the drive in the optical bay bracket
Predisassembly procedures on page
Removing the side access panel on page
while sliding the drive with rails into the drive bracket
Removing and installing components 117
73).
75).
as
2