Parts Removal and Replacement
Memory Card(s) DIMMS
Figure 2-7. Removing a DIMM
Ejector Tab
2. Grasp the memory card by its edges and lift it straight out. Place the card on the
conductive sheeting.
3. Repeat steps 1 and 2 for all memory cards.
Replacing the Memory Card(s) (DIMMs)
1. Refer to the label in the system for correct installation sequence.
2. Make sure the ejector tabs are angled outward. Align the notched edge of the memory
card with its slot. Insert the memory card and firmly and evenly push down on each
side to lock it into place. The ejector tabs will angle upward.
3. Visually inspect and confirm the connection between the memory card and the system
board.
4. Repeat steps 1 and 2 for all memory cards.
5. Replace the Front Air Guides and Support Bars.
18
Ejector Tab
Chapter 2