Top, Front, And Side Panels; Removing The Front Panel - HP Visualize J5000 - Workstation Manual
Visualize j class unix workstations
Hide thumbs
Also See for Visualize J5000 - Workstation:
- Supplementary manual (214 pages) ,
- Owner's manual (212 pages) ,
- Handbook (178 pages)
Table of Contents
Advertisement
Parts Removal and Replacement
Top, Front, and Side Panels
Top, Front, and Side Panels
This section describes how to remove and replace the top, front, and side panels.
Removing the Front Panel
1. Power down your workstation as described in "Getting Started." If locked, unlock the
door on the front of the system and swing it to the right (see Step 1 in the figure below).
2. Once the door is open, unscrew the two panel-detach screws in the top and bottom
corners of the right edge of the panel. These screws are visible when the door is open.
3. Swing the entire front panel 45 to 90 to the left (Step 3 in the figure below).
4. Pull the panel straight out to remove it (Step 4 in the figure below). Set the panel and
its screws aside.
Figure 2-1. Removing the Front Panel
4
12
3
4
T-15 T
1
Chapter 2
Advertisement
Table of Contents
Need help?
Do you have a question about the Visualize J5000 - Workstation and is the answer not in the manual?
Questions and answers