Replacing Pci Cards - HP Visualize J5000 - Workstation Manual

Visualize j class unix workstations

Hide thumbs Also See for Visualize J5000 - Workstation:

Table of Contents

Replacing PCI Cards

CAUTION

To avoid damaging the PCI card connectors, do not rock a PCI card from side

to side when inserting it.

Figure 2-14. The PCI Card Cage

Empty PCI Slots

PCI I/O Card

1. Align the edges of the PCI card with the guide rails on the I/O fan bracket (if they are

full-length cards) and ﬁrmly push to slide the card into the slot on the I/O board.

Visually inspect and conﬁrm the connection between the PCI card(s) and the I/O board.

NOTE

If the PCI card will not slide in, look at the slots from the back of the

workstation. Protrusions on the face plate of the PCI card may be causing the

obstruction.

2. Replace the T-15 Torx screw that secures the PCI card to the workstation

3. Repeat steps 1 and 2 for all PCI cards.

Chapter 2

Parts Removal and Replacement

PCI I/O Cards

Screws securing

PCI cards or

ﬁller plates

Table of Contents

Do you have a question about the Visualize J5000 - Workstation and is the answer not in the manual?

Visualize j7000