Parts Removal and Replacement
System Board Cooling Fans
System Board Cooling Fans
This section describes how to remove and replace the System Board Cooling Fans.
NOTE
Prior to removing the System Board Cooling Fans, the Front, Top, and Side
panels need to be removed. See the appropriate section(s) for removing and
replacing these components.
Removing the Front Air Guides and Support Bars (J7000 Only)
Figure 2-45. J7000's Open Left Side Before Removing Air Guide
Support
Bar
Front
Air
Guide
Support
Bar
1. Remove the four T-15 Torx screws from the front air guide. This will release it from the
support bar. Pull the front air guide straight out.
50
Four
T-15
Torx
Screws
Chapter 2
Need help?
Do you have a question about the Visualize J5000 - Workstation and is the answer not in the manual?
Questions and answers