Replacement Part Kit Contents; Required Tools; Safely Powering Down The J Class Workstation - HP Visualize J5000 - Workstation Manual

Getting Started

Replacement Part Kit Contents

• Connect all equipment together, including the static-free mat, static strap, clips
attached to the wrist strap, and peripheral units.
• Keep uninstalled printed circuit boards in their protective antistatic bags.
• Once you have removed printed circuit boards from their protective antistatic bags,
handle the printed circuit boards by their edges only.
Replacement Part Kit Contents
Take a moment to verify that your kit contains the following contents:
• Replacement Part
• Part Number: A3024-80004, Electrostatic Discharge (ESD) Materials
• Removal/Replacement Guide
If you are missing any part or any documentation, please call your designated service
representative.

Required Tools

You will need the following tools for removal/replacement procedures:
• T-10 or T-15 Torx drivers
• Light-duty flat blade screwdriver with a 150mm (6-inch) blade
• Needle-nose pliers
• ESD materials

Safely Powering Down the J Class Workstation

You must complete the following steps before performing any of the removal and
replacement procedures:
CAUTION Do not use the power supply interlock thumbscrew on the rear panel to power
down the workstation. This power down method may hang the operating
system in an unrecoverable state.
8 Chapter 1