Replacing The Power Supply - HP Visualize J5000 - Workstation Manual

Parts Removal and Replacement
Power Supply
4. Remove the two T-15 Torx screws that connect the power supply to the rear wall of the
chassis and the one in the lower left corner of the power supply (Step 4 below).
Figure 2-9. Removing the Power Supply, Steps 4–5
Step 4: Remove
T-15 Torx Screws
5. Remove the power supply by alternately loosening the two jack screws from the upper
corners of the power supply (Step 5 above). Keep loosening the screws alternately until
you can slide the power supply toward you and off the guide rails. (The jack screws
remain attached to the power supply when it is removed.)
WARNING The power supply is heavy, weighing approximately 17 pounds (7.7
kilograms). Be prepared to handle the weight when you slide it off of
the guide rails, or injury may result.

Replacing the Power Supply

CAUTION To prevent system damage, inspect the power supply making sure no cables
are obstructing the guide rails before trying to slide the power supply back
into place.
1. Align the power supply with the guide rails and slide it into the I/O board connectors.
Alternately tighten the two jack screws (in the upper corners of the power supply). Take
care to align the right-side jack screw to the threads in the back of the workstation
chassis (see Step 1 below).
20
Step 5: Remove
Jack Screws
Chapter 2