Clustering Aps By Using Snmp; Configuring Client Qos; Configuring Qos By Using The Web Interface; Acl Configuration - D-Link DWL-3600AP Administrator's Manual

Unified Access Point Administrator's Guide Configuring Client QoS
Clustering APs by Using SNMP
Cluster configuration by using SNMP is not supported.
Configuring Client QoS
This example shows how to enable client QoS, configure an ACL and a DiffServ policy on the AP, and to apply
the ACL and the Policy to traffic transmitted from clients associated with VAP 2 and received by the AP.
The IPv4 ACL is named acl1 and contains two rules. The first rule allows HTTP traffic from the 192.168.1.0
subnet. The second rule allows all IP traffic from the management station (192.168.1.23). All other traffic is
denied due to the implicit deny all rule at the end of the ACL. The ACL is applied to the inbound interface on
the AP so that packets are checked when the AP receives traffic from associated clients.
The DiffServ policy in this example shows how to establish default DiffServ behavior for clients associating with
the VAP that do not obtain a DiffServ policy name through the RADIUS server. Voice traffic (UDP packets)
received from clients in the 192.168.1.0 subnet that has the VoIP server as its destination address
(192.168.2.200), is marked with the IP DSCP value for expedited forwarding so that it takes priority over other
traffic.
Configuring QoS by Using the Web Interface
ACL Configuration
1. Log onto the AP and navigate to the Client QoS > Client QoS ACL page.
2. Enter acl1in the ACL Name field, and click Add ACL.
The screen refreshes, and additional fields appear.
3. From the Action menu, select Permit.
4. Clear the Match Every option.
5. Verify that the Protocol option is selected and IP is selected from the Select From List menu.
D-Link Unified Access Point Administrator's Guide
November 2011 Page 174