Using The Cli To Configure Ethernet Settings; Table 5: Cli Commands For Ethernet Setting - D-Link DWL-3600AP Administrator's Manual

Unified Access Point Administrator's Guide
Using the CLI to Configure Ethernet Settings
Use the commands shown in the following table to view and set values for the Ethernet (wired) interface. For
more information about each setting, see the description for the field in Table 17 on page 52.
Action
Get the DNS Name
Set the DNS Name
Get Current Settings for the Ethernet (Wired) Internal
Interface
Set the management VLAN ID
View untagged VLAN information
Enable the untagged VLAN
Disable the untagged VLAN
Set the untagged VLAN ID
View the connection type
Use DHCP as the connection type
Use a Static IP as the connection type
Set the Static IP address
Set a Subnet Mask
Set the Default Gateway
View the DNS Nameserver mode Dynamic= up
Manual=down
Set DNS Nameservers to Use Static IP Addresses (Dynamic
to Manual Mode)
Set DNS Nameservers to Use DHCP IP Addressing (Manual
to Dynamic Mode)
In the following example, the administrator uses the CLI to set the management VLAN ID to 123 and to disable
the untagged VLAN so that all traffic is tagged with a VLAN ID.
D‐Link‐WLAN‐AP# set management vlan‐id 123
D‐Link‐WLAN‐AP# set untagged‐vlan status down
D-Link
November 2011
Table 5: CLI Commands for Ethernet Setting
Configuring the Ethernet Settings
Command
get host id
set host id <host_name>
For example:
set host id vicky‐ap
get management
set management vlan‐id <1‐4094>
get untagged‐vlan
set untagged‐vlan status up
set untagged‐vlan status down
set untagged‐vlan vlan‐id <1‐4094>
get management dhcp‐status
set management dhcp‐status up
set management dhcp‐status down
set management static‐ip <ip_address>
For example:
set management static‐ip 10.10.12.221
set management static‐mask <netmask>
For example:
set management static‐mask 255.255.255.0
set static‐ip‐route gateway <ip_address>
For example:
set static‐ip‐route gateway 10.10.12.1
get host dns‐via‐dhcp
set host dns‐via‐dhcp down
set host static‐dns‐1 <ip_address>
set host static‐dns‐2 <ip_address>
For example:
set host static‐dns‐1 192.168.23.45
set host dns‐via‐dhcp up
Unified Access Point Administrator's Guide
Page 26