Configuring Snmpv3 Targets; Figure 37: Snmpv3 Target; Table 46: Snmpv3 Targets - D-Link DWL-3600AP Administrator's Manual

Unified Access Point Administrator's Guide
Field
Encryption Key
SNMPv3 Users
Note: After you configure the SNMPv3 Users settings, you must click Apply to apply the changes and
to save the settings.
Configuring SNMPv3 Targets
SNMPv3 Targets send "inform" messages to the SNMP manager. Each target is identified by a target name and
associated with target IP address, UDP port, and SNMP user name.
Field Description
IP Address Enter the IP address of the remote SNMP manager to receive the target.
Port Enter the UDP port to use for sending SNMP targets.
Users Enter the name of the SNMP user to associate with the target. To configure SNMP users,
see "Configuring SNMPv3 Users" on page 115.
SNMPv3 Targets This field shows the SNMPv3 Targets on the UAP. To remove a target, select it and click
Remove.
Note: After you configure the SNMPv3 Target settings, you must click Apply to apply the changes and
to save the settings.
D-Link
November 2011
Table 45: SNMP v3 Users (Cont.)
Description
If you specify DES as the privacy type, enter a key to use to encrypt the SNMP requests.
The passphrase must be between 8 and 32 characters in length.
This field shows the users that you have defined on the AP. To remove a user, select the
user and click Remove.
Figure 37: SNMPv3 Target
Table 46: SNMPv3 Targets
Configuring SNMPv3 Targets
Unified Access Point Administrator's Guide
Page 116