Figure 13: Ethernet Settings; Table 17: Ethernet Settings Page - D-Link DWL-3600AP Administrator's Manual

Unified Access Point Administrator's Guide
The following table describes the fields to view or configure on the Ethernet Settings page.
Field Description
Hostname Enter a hostname for the AP. The hostname appears in the CLI prompt.
The hostname has the following requirements:
• The length must be between 1 – 6 3 characters.
• Upper and lower case characters, numbers, and hyphens are accepted.
• The first character must be a letter (a – z or A – Z ), and the last character cannot be a
MAC Address Shows the MAC address for the LAN interface for the Ethernet port on this AP. This is a
read‐only field that you cannot change.
Management VLAN The management VLAN is the VLAN associated with the IP address you use to access the
ID AP. The default management VLAN ID is 1.
Provide a number between 1 and 4094 for the management VLAN ID.
Untagged VLAN If you disable the untagged VLAN, all traffic is tagged with a VLAN ID.
By default all traffic on the UAP uses VLAN 1, which is the default untagged VLAN. This
means that all traffic is untagged until you disable the untagged VLAN, change the
untagged traffic VLAN ID, or change the VLAN ID for a VAP or client using RADIUS.
Untagged VLAN ID Provide a number between 1 and 4094 for the untagged VLAN ID. Traffic on the VLAN
that you specify in this field will not be tagged with a VLAN ID.
Connection Type If you select DHCP, the UAP acquires its IP address, subnet mask, DNS, and gateway
information from a DHCP server.
If you select Static IP, you must enter information in the Static IP Address, Subnet Mask,
and Default Gateway fields.
D-Link
November 2011
Figure 13: Ethernet Settings
Table 17: Ethernet Settings Page
hyphen.
Ethernet Settings
Unified Access Point Administrator's Guide
Page 52