Configuring Snmpv3 Users; Figure 36: Snmpv3 Users; Table 45: Snmp V3 Users - D-Link DWL-3600AP Administrator's Manual

Unified Access Point Administrator's Guide
Configuring SNMPv3 Users
From the SNMPv3 Users page, you can define multiple users, associate the desired security level to each user,
and configure security keys.
For authentication, only MD5 type is supported, and for encryption only DES type is supported. There are no
default SNMPv3 users on the UAP.
Table 45 describes the fields to configure SNMPv3 users.
Field
Name
Group
Authentication Type Select the type of authentication to use on SNMP requests from the user:
Authentication Key
Encryption Type
D-Link
November 2011
Figure 36: SNMPv3 Users
Table 45: SNMP v3 Users
Description
Enter the user name to identify the SNMPv3 user.
User names can contain up to 32 alphanumeric characters.
Map the user to a group. The default groups are RWAuth, RWPriv, and RO. You can
define additional groups on the SNMPv3 Groups page.
• MD5 — R equire MD5 authentication on SNMPv3 requests from the user.
• None — S NMPv3 requests from this user require no authentication.
If you specify MD5 as the authentication type, enter a password to enable the SNMP
agent to authenticate requests sent by the user.
The passphrase must be between 8 and 32 characters in length.
Select the type of privacy to use on SNMP requests from the user:
• DES — U se DES encryption on SNMPv3 requests from the user.
• None — S NMPv3 requests from this user require no privacy.
Configuring SNMPv3 Users
Unified Access Point Administrator's Guide
Page 115