Removing An Access Point From The Cluster; Table 58: Access Points In The Cluster; Table 59: Clustering Options - D-Link DWL-3600AP Administrator's Manual

Unified Access Point Administrator's Guide
The following table describes the configuration and status information available on the cluster Access Points
page.
Field Description
Status If the status field is visible, then the AP is enabled for clustering. If clustering is not enabled,
then the AP is operating in stand‐alone mode and none of the information in this table is
visible.
To disable clustering on the AP, click Stop Clustering.
Location Description of where the access point is physically located.
MAC Address Media Access Control (MAC) address of the access point.
The address shown here is the MAC address for the bridge (
which the AP is known externally to other networks.
IP Address Specifies the IP address for the access point.
Each IP address is a link to the Administration Web pages for that access point. You can use
the links to navigate to the Administration Web pages for a specific access point. This is
useful for viewing data on a specific access point to make sure a cluster member is picking
up cluster configuration changes, to configure advanced settings on a particular access
point, or to switch a standalone access point to cluster mode.
The following table describes the cluster information to configure for an individual member. The clustering
options are read‐only when clustering is enabled. To configure the clustering options, you must stop clustering.
Field
Location
Cluster Name
Clustering IP Version
Removing an Access Point from the Cluster
To remove an access point from the cluster, do the following.
1. Go to the Administration Web pages for the clustered access point.
The Administration Web pages for the standalone access point are displayed.
2. Click the Cluster > Access Points link in the Administration pages.
3. Click Stop Clustering.
The change will be reflected under Status for that access point; the access point will now show as
stand‐alone (instead of cluster).
D-Link
November 2011
Table 58: Access Points in the Cluster
Table 59: Clustering Options
Description
Enter a description of where the access point is physically located.
Enter the name of the cluster for the AP to join.
The cluster name is not sent to other APs in the cluster. You must configure the same
cluster name on each AP that is a member of the cluster. The cluster name must be
unique for each cluster you configure on the network.
Specify the IP version that the APs in the cluster use to communicate with each
other.
Managing Access Points in the Cluster
br0 ). This is the address by
Unified Access Point Administrator's Guide
Page 151