Unified Access Point Administrator's Guide
Section 5: Configuring Access Point Services
This section describes how to configure services on the UAP and contains the following subsections:
•
"Configuring SNMP on the Access Point"
•
"Web Server Settings"
•
"Setting the SSH Status"
•
"Setting the Telnet Status"
•
"Configuring Quality of Service"
•
"Configuring Email Alert"
•
"Enabling the Time Settings (NTP)"
Configuring SNMP on the Access Point
Simple Network Management Protocol (SNMP) defines a standard for recording, storing, and sharing
information about network devices. SNMP facilitates network management, troubleshooting, and
maintenance. The AP supports SNMP versions 1, 2, and 3. Unless specifically noted, all configuration
parameters on this page apply to SNMPv1 and SNMPv2c only.
Key components of any SNMP‐managed network are managed devices, SNMP agents, and a management
system. The agents store data about their devices in Management Information Bases (MIBs) and return this
data to the SNMP manager when requested. Managed devices can be network nodes such as APs, routers,
switches, bridges, hubs, servers, or printers.
The UAP can function as an SNMP managed device for seamless integration into network management systems
such as HP OpenView.
From the SNMP page under the Services heading, you can start or stop control of SNMP agents, configure
community passwords, access MIBs, and configure SNMP Trap destinations.
From the pages under the SNMPv3 heading, you can manage SNMPv3 users and their security levels and define
access control to the SNMP MIBs. For information about how to configure SNMPv3 views, groups, users, and
targets, see "Configuring SNMPv3" on page 111.
To configure SNMP, click the SNMP tab under the Services heading and update the fields described in Table 36
on page 96
D-Link
November 2011
Configuring Access Point Services
Unified Access Point Administrator's Guide
Page 95