Unified Access Point Administrator's Guide
Clustering Access Points
This example shows how to configure a cluster with two APs and to enable automatic channel re‐
assigment.The location of the local AP is Room 214, and the cluster name is MyCluster.
Clustering APs by Using the Web Interface
1. Log onto the AP and navigate to the Cluster > Access Points page.
2. If clustering has started, click Stop Clustering so you can change the Clustering Options.
3. Enter the AP location and the name of the cluster for it to join.
4. Click Apply.
5. Click Start Clustering to enable the clustering feature.
After you refresh the page, other APs that are on the same bridged segment, have radios in the same
operating mode, are enabled for clustering, and have the same cluster name appear in the Access Points
table.
D-Link
November 2011
Clustering Access Points
Unified Access Point Administrator's Guide
Page 172