Clustering Aps By Using The Cli; Clustering Aps By Using Snmp - D-Link DWL-8600AP Administrator's Manual

Software User Manual
12/10/09
C AP
LUSTERING S BY
1. Connect to the AP by using Telnet, SSH, or a serial connection.
2. Set the AP Location.
set cluster cluster-name "Room 214"
Note: If the cluster name or cluster location has spaces, you must enclose the text in quotation marks when
you enter the text in the CLI, as the command example shows. You do not need to use quotation marks when
you enter text by using the Web UI.
3. Set the cluster name.
set cluster location MyCluster
4. Start clustering.
set cluster clustered 1
5. View information about the cluster settings on the AP.
get cluster detail
6. Start the automatic channel planner.
set channel-planner status up
7. View the settings for the automatic channel planner.
get channel-planner detail
C AP
LUSTERING S BY
Cluster configuration by using SNMP is not supported.
34CSFP6XXUAP-SWUM100-D13
U CLI
SING THE
U SNMP
SING
D-Link UAP
Clustering Access Points Page 125