D-Link DWL-3600AP Administrator's Manual page 148

Unified Access Point Administrator's Guide
RADIUS Attribute ID
Vendor‐Specific (26), 14122,7
WISPr‐Bandwidth‐
Max‐Up
Vendor‐Specific (26), 6132,120
LVL7‐Wireless‐Client‐
ACL‐Dn
Vendor‐Specific (26), 6132,121
LVL7‐Wireless‐Client‐
ACL‐Up
Vendor‐Specific (26), 6132,122
LVL7‐Wireless‐Client‐
Policy‐Dn
Vendor‐Specific (26), 6132,123
LVL7‐Wireless‐Client‐
Policy‐Up
D-Link
November 2011
Table 57: Client QoS RADIUS Attributes (Cont.)
Description
Maximum allowed client transmission rate to
the AP in bits per second. If nonzero, the
specified value is rounded down to the nearest
64 Kbps value when used in the AP (64 Kbps
minimum). If zero, bandwidth limiting is not
enforced for the client in this direction.
Access list identifier to be applied to 802.1X
authenticated wireless client traffic in the
outbound (down) direction.
If this attribute refers to an ACL that does not
exist on the AP, all packets for this client will be
dropped until the ACL is defined.
Access list identifier to be applied to 802.1X
authenticated wireless client traffic in the
inbound (up) direction.
If this attribute refers to an ACL that does not
exist on the AP, all packets for this client will be
dropped until the ACL is defined.
Name of DiffServ policy to be applied to 802.1X
authenticated wireless client traffic in the
outbound (down) direction.
If this attribute refers to a policy name that
does not exist on the AP, all packets for this
client will be dropped until the DiffServ policy is
defined.
Name of DiffServ policy to be applied to 802.1X
authenticated wireless client traffic in the
inbound (up) direction.
If this attribute refers to a policy name that
does not exist on the AP, all packets for this
client will be dropped until the DiffServ policy is
defined.
Configuring RADIUS‐Assigned Client QoS Parameters
Type/Range
Type: integer
32‐bit unsigned integer
value (0‐4294967295)
Type: string
5‐36 characters (not null‐
terminated)
The string is of the form
"type:name" where: type =
ACL type identifier: IPV4,
IPV6, MAC
: = required separator
character
name = 1‐31 alphanumeric
characters, specifying the
ACL number (IPV4) or
name (IPV6, MAC)
Type: string
5‐36 characters (not null‐
terminated) The string is of
the form "type:name"
where: type = ACL type
identifier: IPV4, IPV6, MAC
: = required separator
character
name = 1‐31 alphanumeric
characters, specifying the
ACL number (IPV4) or
name (IPV6, MAC)
Type: string
1‐31 characters (not null‐
terminated)
Type: string
1‐31 characters (not null‐
terminated)
Unified Access Point Administrator's Guide
Page 148