Clustering Aps By Using The Cli - D-Link DWL-3600AP Administrator's Manual

Unified Access Point Administrator's Guide
6. Go to the Channel Management page to view the channel assignments.
A table on the page displays the current channel assignments and the proposed channel assignments. The
interval setting in the Advanced section determine how often proposed changes are applied.
Clustering APs by Using the CLI
1. Connect to the AP by using Telnet, SSH, or a serial connection.
2. Stop clustering so you can change the location and cluster name.
set cluster clustered 0
3. Set the AP Location.
set cluster cluster‐name "Room 214"
Note: If the cluster name or cluster location has spaces, you must enclose the text in quotation
marks when you enter the text in the CLI, as the command example shows. You do not need to use
quotation marks when you enter text by using the Web UI.
4. Set the cluster name.
set cluster location MyCluster
5. Start clustering.
set cluster clustered 1
6. View information about the cluster settings on the AP.
get cluster detail
7. Start the automatic channel planner.
set channel‐planner status up
8. View the settings for the automatic channel planner.
get channel‐planner detail
D-Link
November 2011
Clustering Access Points
Unified Access Point Administrator's Guide
Page 173