Wds Configuration Using Snmp - D-Link DWL-3600AP Administrator's Manual
Unified wired & wireless access system
Hide thumbs
Also See for DWL-3600AP:
- Quick installation manual (9 pages) ,
- Specifications (4 pages) ,
- User manual (754 pages)
Table of Contents
Advertisement
Unified Access Point Administrator's Guide
WDS Configuration Using SNMP
1. Load the FASTPATH‐WLAN‐ACCESS‐POINT‐MIB module.
2. From the MIB tree, navigate to the objects in the apIfConfig table.
3. Walk the apIfConfigName object to view the instance ID for the first WDS link (wlan0wds0).
The first WDS link is instance 1.
4. Set the value of instance 1 in the apIfConfigRemoteMac object to 00:30:AB:00:00:B0.
In the MG‐Soft browser, the format for the MAC address value to set is # 0x00 0x30 0xAB 0x00 0x00 0xB0.
5. Set the value of instance 1 in the apIfConfigWdsSecPolicy object to WPA Personal (3).
6. Set the value of instance 1 in the apIfConfigSsid object to wds‐link.
7. Set the value of instance 1 in the apIfConfigWdsWpaPskKey object to abcdefthijk.
Some MIB browsers require that the value be entered in HEX values rather than ASCII values.
8. Perform the same configuration steps on MyAP2.
D-Link
November 2011
Configuring the Wireless Distribution System
Unified Access Point Administrator's Guide
Page 171
Advertisement
Table of Contents
