D-Link DWL-3600AP Administrator's Manual page 107

Unified Access Point Administrator's Guide
Field
Urgent Message
Severity
Non Urgent Severity
Email Alert Mail Server Configuration
Mail Server Address
Mail Server Security
Mail Server Port
Username
Password
Email Alert Message Configuration
To Address 1
To Address 2
To Address 3
Email Subject
Note: After you configure the Email Alert settings, click Apply to apply the changes and to save the
settings.
D-Link
November 2011
Table 41: Email Alert Configuration (Cont.)
Description
Configures the severity level for log messages that are considered to be urgent.
Messages in this category are sent immediately. The security level you select and all
higher levels are urgent:
• Emergency indicates system is unusable. It is the highest level of severity.
• Alert indicates action must be taken immediately.
• Critical indicates critical conditions.
• Error indicates error conditions.
• Warning indicates warning conditions.
• Notice indicates normal but significant conditions.
• Informational indicates informational messages.
• Debug indicates debug‐level messages.
Configures the severity level for log messages that are considered to be nonurgent.
Messages in this category are collected and sent in a digest form at the time interval
specified by the Log Duration field. The security level you select and all levels up to,
but not including the lowest Urgent level are considered nonurgent. Messages
below the security level you specify are not sent via email.
See the Urgent Message field description for information about the security levels.
Specify the IP address or hostname of the SMTP server on the network.
Specify whether to use SMTP over SSL (TLSv1) or no security (Open) for
authentication with the mail server. The default is Open.
Configures the TCP port number for SMTP. The range is a valid port number from 0
to 65535. The default is 25, which is the standard port for SMTP.
Specify the username to use when authentication with the mail server is required.
The username is a 64‐byte character string with all printable characters. The default
is admin.
Specify the password associated with the username configured in the previous field.
Configure the first email address to which alert messages are sent.The address must
be a valid email address. By default, no address is configured.
Optionally, configure the second email address to which alert messages are sent.The
address must be a valid email address. By default, no address is configured.
Optionally, configure the third email address to which alert messages are sent.The
address must be a valid email address. By default, no address is configured.
Specify the text to be displayed in the subject of the email alert message. The subject
can contain up to 255 alphanumeric characters. The default is Log message from AP.
Configuring Email Alert
Unified Access Point Administrator's Guide
Page 107