Wds Configuration From The Cli; Wds Configuration Using Snmp - D-Link DWL-8600AP Administrator's Manual

Software User Manual
12/10/09
WDS C
ONFIGURATION FROM THE
1. Connect to the MyAP1 by using Telnet, SSH, or a serial connection.
2. Configure the remote MAC address for MyAP2.
set interface wlan0wds0 status up remote-mac 00:30:AB:00:00:B0
3. Set WPA (PSK) as the encryption type for the link.
set interface wlan0wds0 wds-security-policy wpa-personal
4. Set the SSID on the WDS link.
set interface wlan0wds0 wds-ssid wds-link
5. Configure the encryption key.
set interface wlan0wds0 wds-wpa-psk-key abcdefghijk
6. Administratively enable the WDS link.
set interface wlan0wds0 status up
7. Perform the same configuration steps on MyAP2.
WDS C
ONFIGURATION
1. Load the DLINK-WLAN-ACCESS-POINT-MIB module.
2. From the MIB tree, navigate to the objects in the apIfConfig table.
3. Walk the apIfConfigName object to view the instance ID for the first WDS link (wlan0wds0).
The first WDS link is instance 1.
4. Set the value of instance 1 in the apIfConfigRemoteMac object to 00:30:AB:00:00:B0.
In the MG-Soft browser, the format for the MAC address value to set is # 0x00 0x30 0xAB 0x00 0x00 0xB0.
5. Set the value of instance 1 in the apIfConfigWdsSecPolicy object to WPA Personal (3).
6. Set the value of instance 1 in the apIfConfigSsid object to wds-link.
7. Set the value of instance 1 in the apIfConfigWdsWpaPskKey object to abcdefthijk.
Some MIB browsers require that the value be entered in HEX values rather than ASCII values.
8. Perform the same configuration steps on MyAP2.
34CSFP6XXUAP-SWUM100-D13
CLI
U SNMP
SING
Configuring the Wireless Distribution System
D-Link UAP
Page 123