Set Pagebreak; Pagebreak State Parameters - HP StorageWorks 8/20q Command Line Interface Manual

set pagebreak

Description Specifies how much information is displayed on the screen at a time. This command is useful for
disabling pagebreaks to allow command scripts to run without interruption.
Authority None
Syntax
pagebreak [state]
Operands
[state]
Table 43
Table 43
Parameter
on
off
Examples The following is an example of the set pagebreak command:
8/20q FC Switch #> set pagebreak on
8/20q FC Switch #> zone list
Zone
----
Zone1
Zone2
Zone3
Zone4
See also show pagebreak, page 256
208 Command Reference
describes the pagebreak state parameters.

Pagebreak state parameters

Description
Limits the display of information to 20 lines at a time. The page break function
affects the following commands:
• alias (list, members)
• show (alarm, log)
• zone (list, members)
• zoneset (list, zones)
• zoning (active, list)
Allows continuous display of information without a break. This is the default.
ZoneSet
-------
alpha
beta
delta
echo
sierra
tango
gamma
delta
Press any key to continue, 'q' to quit ...