HP StorageWorks 8/20q Command Line Interface Manual page 164

Examples The following is an example of the ipsec association create command:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> ipsec edit
8/20q FC Switch (admin-ipsec) #> ipsec association create h2h-sh-sa
A list of attributes with formatting will follow.
Enter a value or simply press the ENTER key to skip specifying a value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Required attributes are preceded by an asterisk.
Value (press ENTER to not specify value, 'q' to quit):
Description
*SourceAddress
*DestinationAddress (hostname, IPv4, or IPv6 Address)
*Protocol
*SPI
Authentication
*AuthenticationKey
*Encryption
*EncryptionKey
The security association has been created.
This configuration must be saved with the 'ipsec save' command
before it can take effect, or to discard this configuration
use the 'ipsec cancel' command.
See also ipsec, page 160
ipsec list, page 165
ipsec policy, page 168
164 Command Reference
(string value, 0-127 bytes)
(hostname, IPv4, or IPv6 Address)
(1=esp, 2=esp-old, 3=ah, 4=ah-old)
(decimal value, 256-4294967295)
(select an authentication algorithm)
1=hmac-md5
2=hmac-sha1
3=hmac-sha256
4=aes-xcbc-mac
authentication algorithm choice
(quoted string or raw hex bytes):
(select an encryption algorithm)
1=des-cbc
2=3des-cbc
3=null
4=blowfish-cbc
5=aes-cbc
6=twofish-cbc
encryption algorithm choice
(quoted string or raw hex bytes): "123456789012345678901234"
:
Host-to-host:switch->host
:
fe80::2c0:ddff:fe03:d4c1
:
fe80::250:daff:feb7:9d02
:
:
(16 byte key)
(20 byte key)
(32 byte key)
(16 byte key)
:
"12345678901234567890"
(8 byte key)
(24 byte key)
(0 byte key)
(5-56 byte key)
(16/24/32 byte key)
(16-32 byte key)
:
1
333
2
2