Modifying The Snmp Configuration - HP StorageWorks 8/20q Command Line Interface Manual

Modifying the SNMP configuration

To modify the SNMP configuration, enter the set setup snmp command in an Admin session. There
are two groups of configuration parameters. One group is common to all traps; the second group is
trap-specific. You can configure both groups of parameters for all SNMP traps, or you can configure the
common and trap-specific parameters separately. See
parameters.
The following example sets the common trap parameters for all SNMP traps:
8/20q FC Switch (admin) #> set setup snmp common
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
SnmpEnabled
Contact
Location
ReadCommunity
WriteCommunity
AuthFailureTrap
ProxyEnabled
SNMPv3Enabled
New Value (press ENTER to not specify value, 'q' to quit):
SnmpEnabled
Contact
Location
ReadCommunity
WriteCommunity
AuthFailureTrap
ProxyEnabled
SNMPv3Enabled
Do you want to save and activate this snmp setup? (y/n): [n]
True
<sysContact undefined>
<sysLocation undefined>
public
private
False
True
False
(True / False)
(string, max=64 chars) :
(string, max=64 chars) :
(string, max=32 chars) :
(string, max=32 chars) :
(True / False)
(True / False)
(True / False)
HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Guide 119
Table 50 for descriptions of the common SNMP
:
:
:
: