HP StorageWorks 8/20q Command Line Interface Manual page 170

rename [policy_old] [policy_new]
Renames the policy given by [policy_old] to the policy given by [policy_new]. You must enter the
ipsec save command afterwards to save your changes. Dynamic policies cannot be renamed.
Examples The following is an example of the ipsec policy create command:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> ipsec edit
8/20q FC Switch (admin-ipsec) #> ipsec policy create h2h-sh-sp
A list of attributes with formatting will follow.
Enter a value or simply press the ENTER key to skip specifying a value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Required attributes are preceded by an asterisk.
Value (press ENTER to not specify value, 'q' to quit):
Description
*SourceAddress
SourcePort
*DestinationAddress (IPv4, IPv6 or hostname/[PrefixLength])
DestinationPort
*Protocol
*Direction
Priority
*Action
*ProtectionDesired
*espRuleLevel
The security policy has been created.
This configuration must be saved with the 'ipsec save' command
before it can take effect, or to discard this configuration
use the 'ipsec cancel' command.
See also ipsec, page 160
ipsec association, page 162
ipsec list, page 165
170 Command Reference
(string value, 0-127 bytes)
(IPv4, IPv6 or hostname/[PrefixLength])
(decimal value, 1-65535)
(decimal value, 1-65535)
(decimal value, or keyword)
Allowed keywords
icmp, icmp6, ip4, tcp, udp or any
(1=in, 2=out)
(value, -2147483647 to +214783647)
(1=discard, 2=none, 3=ipsec)
(select one, transport-mode only)
1=ah Authentication Header
2=esp Encapsulating Security Payload
3=both
(1=default, 2=use, 3=require)
:
Host-to-host: switch->host
:
fe80::2c0:ddff:fe03:d4c1
:
:
fe80::250:daff:feb7:9d02
:
:
:
:
:
:
:
any
2
3
2
3