HP StorageWorks 8/20q Command Line Interface Manual page 159

Examples The following is an example of the image install command:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> image install
The switch will be reset.
to I/O traffic.
Continuing with this action will terminate all management sessions,
including any Telnet sessions. When the firmware activation is complete,
you may log in to the switch again.
Do you want to continue? [y/n]: y
Press 'q' and the ENTER key to abort this command.
FTP or TFTP
User Account
IP Address
Source Filename : 8.0.4.xx.xx_epc
About to install image.
Connected to 10.0.0.254 (10.0.0.254).
220 localhost.localdomain FTP server (Version wu-2.6.1-18) ready.
331 Password required for johndoe.
Password: xxxxxxxxx
230 User johndoe logged in.
bin
200 Type set to I.
verbose
Verbose mode off.
This may take several seconds...
The switch will now reset.
Connection closed by foreign host.
The following is an example of the image fetch and image unpack commands:
8/20q FC Switch (admin) #> image fetch johndoe 10.0.0.254 8.0.4.xx.xx_epc
>ftp 10.0.0.254
user:johndoe
password: ********
ftp>bin
ftp>put 8.0.4.xx.xx_epc
ftp>quit
8/20q FC Switch (admin) $>image list
8/20q FC Switch (admin) $>image unpack 8.0.4.xx.xx_epc
Image unpack command result: Passed
See also firmware install, page 146
This process will cause a disruption
: ftp
: johndoe
: 10.0.0.254
Do you want to continue? [y/n] y
HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Guide 159