Set Config Security Portbinding; Port Binding Configuration Parameters - HP StorageWorks 8/20q Command Line Interface Manual

set config security portbinding

Description Configures port binding.
Authority Admin session and a Config Edit session
Syntax
set config security portbinding [port_number]
Operands
[port_number]
Initiates an editing session in which to change the port binding configuration for the port given by
[port_number]. The system displays each parameter one line at a time and prompts you for a value.
For each parameter, enter a new value or press Enter to accept the current value shown in brackets.
Enter q or Q to end the editing session.
portbinding parameters.
Table 35

Port binding configuration parameters

Parameter
PortBindingEnabled
WWN
Examples The following is an example of the set config security portbinding command:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) config edit
8/20q FC Switch (admin-config) #> set config security portbinding 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current
value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
PortBindingEnabled (True / False)[False] true
WWN
WWN
WWN
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
See also show config security
Table 35
Description
Enables (True) or disables (False) port binding for the port
given by [port_number]. The default is False.
Worldwide port name for the port/device that is allowed to
connect to the port given by [port_number].
(N=None / WWN)[None ] 10:00:00:c0:dd:00:b9:f9
(N=None / WWN)[None ] 10:00:00:c0:dd:00:b9:f8
(N=None / WWN)[None ] n
portbinding, page 237
HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Guide 199
describes the set config security