Ipv4 Ethernet Configuration Parameters; Ipv6 Ethernet Configuration Parameters - HP StorageWorks 8/20q Command Line Interface Manual

ipv4
Prompts you in a line-by-line fashion to change the switch IPv4 Ethernet configuration parameters
described in
parameter, enter a new value or press Enter to accept the current value.
NOTE:
Table 53
Parameter
EthIPv4NetworkEnable
EthIPv4NetworkDiscovery Ethernet boot method:
EthIPv4NetworkAddress
EthIPv4NetworkMask
EthIPv4GatewayAddress
Operands
ipv6
Prompts you in a line-by-line fashion to change the switch IPv6 Ethernet configuration parameters
described in
parameter, enter a new value or press Enter to accept the current value.
NOTE:
Table 54
Parameter
EthIPv6NetworkEnable
EthIPv6NetworkDiscovery
EthIPv6NetworkAddress
EthIPv6GatewayAddress
222 Command Reference
Table 53. To configure all system parameters, omit the operand. For each
Changing the IP address will terminate all Ethernet management sessions.

IPv4 Ethernet configuration parameters

Table 54. To configure all system parameters, omit the operand. For each
Changing the IP address will terminate all Ethernet management sessions.

IPv6 Ethernet configuration parameters

Description
Enables (True) or disables (False) the IPv4 interface. The default
is True.
•
1—Static
• 2—Bootp (Bootstrap Protocol)
• 3—DHCP (Dynamic Host Configuration Protocol)
• 4—RARP (Reverse Address Resolution Protocol)
The default is 1-Static.
Ethernet IP address. The default is 10.0.0.1.
Ethernet subnet mask address. The default is 255.0.0.0.
Ethernet IP address gateway. The default is 10.0.0.254
Description
Enables (True) or disables (False) the IPv6 interface. The
default is True.
Ethernet boot method:
• 1—Static
• 2—DHCPv6 (Dynamic Host Configuration Protocol)
• 3—NDP (Neighbor Discovery Protocol)
The default is Static.
Ethernet IP address
Ethernet IP address gateway.