Copying A Zoneset; Adding Zones To A Zoneset; Removing Zones From A Zoneset; Activating A Zoneset - HP StorageWorks 8/20q Command Line Interface Manual

Copying a zoneset

To copy a zoneset and its contents to a new zoneset, enter the zoneset copy command, as shown in the
following example:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> zoning edit
8/20q FC Switch (admin-zoning) #> zoneset copy zoneset_1 zoneset_2
8/20q FC Switch (admin-zoning) #>zoning save

Adding zones to a zoneset

To add a zone to a zoneset, enter the zoneset add command, as shown in the following example:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> zoning edit
8/20q FC Switch (admin-zoning) #> zoneset add zoneset_1 zone_1 zone_2
8/20q FC Switch (admin-zoning) #>zoning save

Removing zones from a zoneset

To remove zones from a zoneset, enter the zoneset remove command, as shown in the following
example:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> zoning edit
8/20q FC Switch (admin-zoning) #> zoneset remove zoneset_1 zone_1 zone_2
8/20q FC Switch (admin-zoning) #>zoning save

Activating a zoneset

To apply zoning to the fabric, enter the zoneset activate command, as shown in the following
example:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> zoneset activate zoneset_1

Deactivating a zoneset

To deactivate the active zoneset and disable zoning in the fabric, enter the zoneset deactivate
command, as shown in the following example:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> zoneset deactivate

Managing zones

This sub-section describes the zone management tasks. All of these tasks require an Admin session and a
Zoning Edit session.

Creating a zone

To create a new zone, enter the zone create command, as shown in the following example:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> zoning edit
8/20q FC Switch (admin-zoning) #> zone create zone_1
8/20q FC Switch (admin-zoning) #> zoning save

Deleting a zone

To delete zone_1 from the zoning database, enter the zone delete command, as shown in the following
example:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> zoning edit
8/20q FC Switch (admin-zoning) #> zone delete zone_1
8/20q FC Switch (admin-zoning) #> zoning save
HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Guide 79