Configuring The Call Home Service - HP StorageWorks 8/20q Command Line Interface Manual

Configuring the Call Home service

To configure the Call Home service, enter the set setup callhome command in an Admin session, as
shown in the following example. See
entries.
8/20q FC Switch (admin) #> set setup callhome
A list of attributes with formatting and current values will follow. Enter a new
value or simply press the ENTER key to accept the current value. If you wish to
terminate this process before reaching the end of the list press 'q' or 'Q' and
the ENTER key to do so.
If either the Primary or Secondary SMTP Servers are enabled, the FromEmailAddress
attribute must be configured or the switch will not attempt to deliver messages.
Current Values:
PrimarySMTPServerAddr
PrimarySMTPServerPort
PrimarySMTPServerEnable
SecondarySMTPServerAddr
SecondarySMTPServerPort
SecondarySMTPServerEnable
ContactEmailAddress
PhoneNumber
StreetAddress
FromEmailAddress
ReplyToEmailAddress
ThrottleDupsEnabled
New Value (press ENTER to accept current value, 'q' to quit):
PrimarySMTPServerAddr
PrimarySMTPServerPort
PrimarySMTPServerEnable
SecondarySMTPServerAddr
SecondarySMTPServerPort
SecondarySMTPServerEanble
ContactEmailAddress
PhoneNumber
StreetAddress
FromEmailAddress
ReplyToEmailAddress
ThrottleDupsEnabled
Do you want to save and activate this Callhome setup? (y/n):
108 Call Home Configuration
Table 46 for a description of the Call Home service configuration
0.0.0.0
25
False
0.0.0.0
25
False
nobody@localhost.localdomain
<undefined>
<undefined>
nobody@localhost.localdomain
nobody@localhost.localdomain
True
(hostname, IPv4, or IPv6 Address):
(decimal value)
(True / False)
(hostname, IPv4, or IPv6 Address):
(decimal value)
(True / False)
(ex: admin@company.com)
(ex: +1-800-123-4567)
(include all address info)
(ex: bldg3@company.com)
(ex: admin3@company.com)
(True / False)
:
:
:
:
:
:
:
:
:
: