Route Map Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Command Reference Manual

The following table describes the Network Filter Configuration Menu options.
Network Filter Configuration Menu options
Table 128
Command
addr <IP address>
mask <IP subnet mask>
enable
disable
delete
current

Route Map configuration

Command: /cfg/l3/rmap <1-32>
[IP Route Map 1 Menu]
Routing maps control and modify routing information. The map number <1-32> represents the routing
map you wish to configure.
The following table describes the Route Map Configuration Menu options.
Route Map Configuration Menu options
Table 129
Command
alist <1-8>
metric <0-16777214>|none
type 1|2|none
prec <1-255>
enable
disable
Description
Sets the starting IP address for this filter. The default address is 0.0.0.0.
Sets the IP subnet mask that is used with /cfg/l3/nwf/addr to define the
range of IP addresses that will be accepted by the peer when the filter is
enabled. The default value is 0.0.0.0.
Enables the Network Filter configuration.
Disables the Network Filter configuration.
Deletes the Network Filter configuration.
Displays the current the Network Filter configuration.
alist - Access List number
metric - Set metric of the matched route
type - Set OSPF metric-type of the matched route
prec - Set the precedence of this route map
enable - Enable route map
disable - Disable route map
delete - Delete route map
current - Display current route map configuration
Description
Displays the Access List menu.
Sets the metric of the matched route.
Assigns the type of OSPF metric. The default is type 1.
Sets the precedence of the route map. The smaller the value, the higher the
precedence. Default value is 10.
Enables the route map.
Disables the route map.
1—External routes are calculated using both internal and external
metrics.
2—External routes are calculated using only the external metrics. Type 2
routes have more cost than Type 2.
none—Removes the OSPF metric.
Configuration Menu
151