Layer 3 Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Command Reference Manual

IMPORTANT:
VLAN and which is not a member of any other VLAN is automatically added to default VLAN #1.
You cannot remove a port from VLAN #1 if the port has no membership in any other VLAN. Also,
you cannot add a port to more than one VLAN unless the port has VLAN tagging turned on. See the
tag command, in the "Port configuration" section earlier in this chapter.

Layer 3 configuration

Command: /cfg/l3
[Layer 3 Menu]
The following table describes the Layer 3 Configuration Menu options.
L3 Configuration Menu options
Table 121
Command
if <1-256>
gw <1-4>
route
arp
frwd
nwf <1-256>
rmap <1-32>
rip
ospf
igmp
dns
bootp
vrrp
All ports must belong to at least one VLAN. Any port which is removed from a
if - Interface Menu
gw - Default Gateway Menu
route - Static Route Menu
arp - ARP Menu
frwd - Forwarding Menu
nwf - Network Filters Menu
rmap - Route Map Menu
rip - Routing Information Protocol Menu
ospf - Open Shortest Path First (OSPF) Menu
igmp - IGMP Menu
dns - Domain Name System Menu
bootp - Bootstrap Protocol Relay Menu
vrrp - Virtual Router Redundancy Protocol Menu
rtrid - Set router ID
cur - Display current IP configuration
Description
Displays the IP Interface Menu.
Displays the IP Default Gateway Menu.
Displays the IP Static Route Menu.
Displays the ARP (Address Resolution Protocol) Menu.
Displays the IP Forwarding Menu.
Displays the Network Filter Configuration Menu.
Displays the Route Map Menu.
Displays the Routing Interface Protocol Menu.
Displays the OSPF Menu.
Displays the IGMP Menu.
Displays the IP Domain Name System Menu.
Displays the Bootstrap Protocol Menu.
Displays the Virtual Router Redundancy Configuration Menu.
Configuration Menu
146