Idle Timeout - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Command Reference Manual

Table 2 User access levels
User account Description and tasks performed
User
Oper
Admin
NOTE:
With the exception of the admin user, setting the password to an empty value can disable
access to each user level.
Once you enter the administrator password and it is verified, you are given complete access to the switch.
After logging in, the Main Menu of the CLI is displayed. See the "Menu basics" chapter for a summary of
the Main Menu options.
[Main Menu]
info
stats
cfg
oper
boot
maint
diff
apply
save
revert
exit
>> Main#

Idle timeout

By default, the switch will disconnect the console, Telnet, or SSH session after five minutes of inactivity.
This function is controlled by the idle timeout parameter, which can be set from 1 to 60 minutes. For
information on changing this parameter, see the "System configuration" section in the "Configuration
Menu" chapter.
The user has no direct responsibility for switch management. He or she can view all switch status
information and statistics, but cannot make any configuration changes to the switch. The user
account is enabled by default, and the default password is user.
The operator manages all functions of the switch. The operator can reset ports or the entire
switch. By default, the operator account is disabled and has no password.
The super user administrator has complete access to all menus, information, and configuration
commands on the switch, including the ability to change both the user and administrator
passwords. The admin account is enabled by default, and the default password is admin.
- Information Menu
- Statistics Menu
- Configuration Menu
- Operations Command Menu
- Boot Options Menu
- Maintenance Menu
- Show pending config changes
- Apply pending config changes [global command]
- Save updated config to FLASH [global command]
- Revert pending or applied changes [global command]
- Exit [global command, always available]
Command line interface
[global command]
13