Port Acl/Qos Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Command Reference Manual

The following table describes the Gigabit Link Configuration Menu options.
Gigabit Link Configuration Menu options
Table 100
Command
speed 10|100|1000|any
mode full|half|any
fctl rx|tx|both|none
auto on|off
cur

Port ACL/QoS configuration

Command: /cfg/port <port number>/aclqos
[Port 20 ACL Menu]
The following table describes the port ACL/QoS Configuration Menu options.
Port ACL/QoS Configuration Menu options
Table 101
Command
add acl <1-896>| grp <1-896>
rem acl <1-896>| grp <1-896>
cur
Description
Sets the link speed. Not all options are valid on all ports. The choices include:
10 Mbps
100 Mbps
1000 Mbps
any, for automatic detection (default)
NOTE: Ports 19-21 are set to 10000 Mbps, and cannot be changed.
Sets the operating mode. Not all options are valid on all ports. The choices
include:
Full-duplex
Half-duplex
any, for automatic detection (default)
NOTE: Ports 19-21 are set to full duplex, and cannot be changed.
Sets the flow control. The choices include:
Receive (rx) flow control
Transmit (tx) flow control
Both receive and transmit flow control (default)
No flow control
Enables or disables auto-negotiation for the port.
Ports 19-21 are set to 10000 Mbps, and cannot be set to auto-negotiate.
NOTE:
Displays current port parameters.
add - Add ACL or ACL group to this port
rem - Remove ACL or ACL group from this port
cur - Display current ACLs for this port
Description
Assigns an ACL or ACL Group to the port.
Removes an ACL or ACL Group from the port.
Displays current port ACL/QoS parameters.
Configuration Menu
128