Spanning Tree Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Command Reference Manual

Table 109 CIST Port Configuration Menu options
Command
edge disable|enable
on
off
cur

Spanning Tree configuration

Command: /cfg/l2/stp <1-128>
[Spanning Tree Group 1 Menu]
The HP 1:10GbE switch supports the IEEE 802.1d Spanning Tree Protocol (STP) and Cisco proprietary
PVST and PVST+ protocols. You can configure up to 127 spanning tree groups on the switch (STG 128 is
reserved for switch management). Spanning Tree is turned on by default.
NOTE: When RSTP is turned on, only STP group 1 can be configured.
The following table describes the Spanning Tree Configuration Menu options.
Table 110 Spanning Tree Configuration Menu options
Command
brg
port <port number>
add <1-4095>
remove <1-4095>
clear
on
off
default
Description
Enables or disables this port as an edge port. An edge port is not connected to
a bridge, and can begin forwarding traffic as soon as the link is up. Configure
server ports as edge ports (enabled). This command is disabled by default.
Enables CIST on the port.
Disables CIST on the port.
Displays the current CIST port configuration.
brg - Bridge parameter menu
port - Port parameter menu
add - Add VLAN(s) to Spanning Tree Group
remove - Remove VLAN(s) from Spanning Tree Group
clear - Remove all VLANs from Spanning Tree Group
on - Globally turn Spanning Tree ON
off - Globally turn Spanning Tree OFF
default - Default Spanning Tree and Member parameters
cur - Display current bridge parameters
Description
Displays the Bridge Spanning Tree Menu.
Displays the Spanning Tree Port Menu.
Associates a VLAN with a spanning tree and requires an external VLAN ID as a
parameter.
Breaks the association between a VLAN and a spanning tree and requires an external
VLAN ID as a parameter.
Removes all VLANs from a spanning tree.
Globally enables Spanning Tree Protocol.
Globally disables Spanning Tree Protocol.
Restores a spanning tree instance to its default configuration.
Configuration Menu
137