First-Time Configuration; Introduction - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Command Reference Manual

First-time configuration

Introduction

This chapter describes how to perform first-time configuration and how to change system passwords.
To begin first-time configuration of the switch, perform the following steps.
1. Connect to the switch console. After connecting, the login prompt displays.
HP 1:10Gb Ethernet Blade Switch
Copyright(C)2006 Hewlett-Packard Development Company, L.P.
Password:
2.
Enter admin as the default administrator password.
The system displays the Main Menu with administrator privileges.
[Main Menu]
info
stats
cfg
oper
boot
maint
diff
apply
save
revert
exit
>> Main#
3. From the Main Menu, enter the following command to access the Configuration Menu:
Main# /cfg
The Configuration Menu is displayed.
[Configuration Menu]
sys
port
l2
l3
qos
acl
rmon
pmirr
ufd
dump
ptcfg
gtcfg
cur
- Information Menu
- Statistics Menu
- Configuration Menu
- Operations Command Menu
- Boot Options Menu
- Maintenance Menu
- Show pending config changes
- Apply pending config changes [global command]
- Save updated config to FLASH [global command]
- Revert pending or applied changes [global command]
- Exit [global command, always available]
- System-wide Parameter Menu
- Port Menu
- Layer 2 Menu
- Layer 3 Menu
- QOS Menu
- Access Control List Menu
- RMON Menu
- Port Mirroring Menu
- Uplink Failure Detection Menu
- Dump current configuration to script file
- Backup current configuration to FTP/TFTP server
- Restore current configuration from FTP/TFTP server
- Display current configuration
First-time configuration
[global command]
20