HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Command Reference Manual page 131

The following table describes the 802.1x Global Configuration Menu options.
802.1x Global Configuration Menu options
Table 104
Command
mode force-
unauth|auto|force-
auth
qtperiod <0-65535>
txperiod <1-65535>
suptmout <1-65535>
svrtmout <1-65535>
maxreq <1-10>
raperiod <1-604800>
reauth on|off
default
cur
Description
Sets the type of access control for all ports:
force-unauth - the port is unauthorized unconditionally.
auto - the port is unauthorized until it is successfully authorized by the RADIUS
server.
force-auth - the port is authorized unconditionally, allowing all traffic.
The default value is force-auth.
Sets the time, in seconds, the authenticator waits before transmitting an EAP-Request/
Identity frame to the supplicant (client) after an authentication failure in the previous
round of authentication. The default value is 60 seconds.
Sets the time, in seconds, the authenticator waits for an EAP-Response/Identity frame
from the supplicant (client) before retransmitting an EAP-Request/Identity frame. The
default value is 30 seconds.
Sets the time, in seconds, the authenticator waits for an EAP-Response packet from
the supplicant (client) before retransmitting the EAP-Request packet from the
authentication server. The default value is 30 seconds.
Sets the time, in seconds, the authenticator waits for a response from the Radius
server before declaring an authentication timeout. The default value is 30 seconds.
The time interval between transmissions of the RADIUS Access-Request packet
containing the supplicant's (client's) EAP-Response packet is determined by the
current setting of /cfg/sys/radius/timeout (default is 3 seconds).
Sets the maximum number of times the authenticator retransmits an EAP-Request
packet to the supplicant (client). The default value is 2.
Sets the time, in seconds, the authenticator waits before re-authenticating a supplicant
(client) when periodic re-authentication is enabled. The default value is 3600
seconds.
Sets the re-authentication status to on or off. The default value is off.
Resets the global 802.1x parameters to their default values.
Displays current global 802.1x parameters.
Configuration Menu
131